HPE EVA Storage

MSA2000G3 SAS Management Ports

 
PZel
Trusted Contributor

MSA2000G3 SAS Management Ports

Two questions:

1) Only one management port of the two is active, with that one you can access the SMU. Both of them are using a unique fixed IP adresss in my situation.  Can you force the MSA (by CLI or SMU) to use the standby management controller instead of the active, or is a failover the only choice  ???

2) The management is default Auto-negiotated i presume. Is it possible (by CLI) to adjust the parameters of the management port ???

PZ
2 REPLIES 2
Torsten.
Acclaimed Contributor

Re: MSA2000G3 SAS Management Ports

Both Management controllers (mc) are active always.

 

 

Regarding the network:

 

Syntax set network-parameters
[dhcp]
[ip address]
[netmask netmask]
[gateway gateway]
[controller a|b]
[ping-broadcast enabled|disabled|on|off]
[link-speed 10mbps|100mbps]
[duplex-mode full|half]
[auto-negotiation enabled|disabled|on|off]
[prompt yes|no]
[noprompt]


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
PZel
Trusted Contributor

Re: MSA2000G3 SAS Management Ports

Thanks, both interface's are working now (Applied in SMU and reset via restart MC a/b)
PZ