HPE EVA Storage

Mapping of MSA2312fc volume to an ESX host is not working

 
SOLVED
Go to solution
toaster
Occasional Contributor

Mapping of MSA2312fc volume to an ESX host is not working

Hello,
I would map an new volume from our MSA to an ESX host. I do the zoning on the san switch (MSA<->ESX) and make an mapping on the MSA for the ESX host.
Then I make an rescan of the HBA in VirtualCenter but I can’t see the volume under storgage adapters ?
Do you have any idea what's going wrong ?

Thanks
2 REPLIES 2
muruggan
Advisor
Solution

Re: Mapping of MSA2312fc volume to an ESX host is not working

Once again check the zoing on switch and the mapping on the MSA. If everything is perfect then try to disable & enable the HBA on SAN switch(i mean the port on the SAN switch where the host is connected). If the issue still persists then reboot the server and check
toaster
Occasional Contributor

Re: Mapping of MSA2312fc volume to an ESX host is not working

You are right. I was a misconfiguration of the zoning. After i correct that the WWN of the HBA of the ESX server appears under hosts on the MSA.

Thank you