HPE Community
HPE EVA Storage
1752318 Members
6386 Online
108786 Solutions
New Discussion

My MSA2312fc show that "Health fault" !!

 
Taohung
Frequent Advisor

‎07-23-2009 12:00 AM

‎07-23-2009 12:00 AM

My MSA2312fc show that "Health fault" !!

My MSA2000 G2 is single 2300 controller.
Any storage operation is OK !!
The message show that second controller is gone , so the health fault information ...

I think that the MSA2000 G2 has dual controllers setting .
How can I delete second controller settin ?
Thank you !!
0 Kudos
Reply
1 REPLY 1
Wickedsunny
Valued Contributor

‎07-23-2009 10:40 PM

‎07-23-2009 10:40 PM

Re: My MSA2312fc show that "Health fault" !!

Log into the cli and run the following command:

Syntax-- set advanced-settings

Turn OFF the following setting.

[partner-notify enabled|disabled|on|off]

Sets whether to notify the partner controller that a trigger condition occurred.

Regards,
Sunny

P:S - Rate solution with points....
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.