HPE EVA Storage

Port not showing in EVA

 
MAH_2
Regular Advisor

Port not showing in EVA

I have 2 switches
Broacade 2/16
EVA 4000
I have configured the zoning on both the switches.
I can see only one port in the command view.
I am using 8Gbps HBA. But other port is able to see. This problem is only for this server.
Anyone can help?????

 

 

P.S. This thread has been moved from General to Storage Area Networks (SAN) (Enterprise). - Hp Forum Moderator

3 REPLIES 3
Steven Clementi
Honored Contributor

Re: Port not showing in EVA

If the EVA can not see the port / wwid, then there is likely a communication issue between the host and the EVA.

Recheck your zoning, recheck your WWID and make sure you tagged the right one in your zone(s), make sure the port is online / logged into the fabric.


Steven
Steven Clementi
HP Master ASE, Storage, Servers, and Clustering
MCSE (NT 4.0, W2K, W2K3)
VCP (ESX2, Vi3, vSphere4, vSphere5, vSphere 6.x)
RHCE
NPP3 (Nutanix Platform Professional)
MAH_2
Regular Advisor

Re: Port not showing in EVA

I can see the port in the switch as connected and reconfigured the zoning also.
Same proble.
But the other port on the other switch is proper.
I don,t know why it is happening?
Mark...
Honored Contributor

Re: Port not showing in EVA

Hi,
As above check zone settings again.
Check the actual port settings on the switch for the EVA port concerned against a "good" one.
Check reseat / replace SFP's at both ends and the cable - with know good SFP's/cable.
Make sure that the port setting on the EVA is NOT set to direct connect.
Mark...
if you have nothing useful to say, say nothing...