HPE EVA Storage

Replacing HSV200-A Controller

 
toufikz
Visitor

Replacing HSV200-A Controller

Hi ,

It 's the first time I use this forum.

I 'm looking for the procedure to replace a controller (HSV200-A) in a redondant configuration (EVA 4000 with 2 Controllers HSV200-A and an FC enclosure ).

Thanks and Best Regards!

 

 

3 REPLIES 3
Torsten.
Acclaimed Contributor

Re: Replacing HSV200-A Controller

shut down the bad controller. transfer the flash memory card. connect power cables only, fans, batteries and power on. if you see input WWN after a while, the controller is good. power off, connect all cables and power on.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
toufikz
Visitor

Re: Replacing HSV200-A Controller

Hi Torsten,

Thanks alot for answering quickly.

Can you tell me how to proceed so as to transfer the flash memory card from old controller to the new one , I don't know how is it !

Thanks !

 

 

Torsten.
Acclaimed Contributor

Re: Replacing HSV200-A Controller

open the little door at the rear side between (10) and (3) and pull the card:

 

EVA-rear.jpg


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!