HPE EVA Storage

SAN Switch configuration problem

 
albert1
Occasional Contributor

SAN Switch configuration problem

Hello ! 

 

I have a HP storage Work 8/24 SAN Switch  (AM868A)  !!

 

I want to config this switch in the simplest way possibe (without Command Line Interface ) !!

 

What can i do ??????

 

Pls Help me ! this is emergency !!!!!!

 

Thanks for your support !!!!

4 REPLIES 4
Sheldon Smith
HPE Pro

Re: SAN Switch configuration problem

If you have the current Java runtime installed on your desktop, you can simply browse to the switch using its IP address. The switch's WebTools should start and prompt you for your username (normally "admin") and the corresponding password.

 

 

Note: While I work for HP, all of my comments (whether noted or not), are my own and are not any official representation of the company.
----------
If my post was useful, click on my KUDOS! thumb below!


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo

AnkitM
Trusted Contributor

Re: SAN Switch configuration problem

While you are using WebTools, you may refer: http://www.brocade.com/downloads/documents/product_manuals/B_SAN/WebTools_AdminGd_v720.pdf for How To's and Steps.

Was your question answered correctly? If so, please remember to mark your question Answered when you get the correct answer and award KUDOS! to the person providing the answer. This helps others searching for a similar issue.
albert1
Occasional Contributor

Re: SAN Switch configuration problem

thanks for your help !!!!!!

 

What is the default IP address , Username and password     ??????

Torsten.
Acclaimed Contributor

Re: SAN Switch configuration problem

see for example

 

http://h30499.www3.hp.com/t5/Switches-Hubs-Modems-Legacy-ITRC/How-to-configure-HP-StorageWorks-8-24-SAN-Switch/td-p/4562774#.VXAUBUbQpHU

 

...

default ip-address is 10.77.77.77. Default username and password is "admin" and "password".

...

 

 

 

a new switch usually comes with an installation flyer with first steps.

 

 

IMHO you better connect the serial cable, log on (9600 baud) and type

 

 

 

swd77:admin> ipaddrset


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!