HPE EVA Storage

Upgrading SAN network advisor from 11.1.0 to 12.0.2 fails at DB migration

 
UlfZimmermann
Occasional Contributor

Upgrading SAN network advisor from 11.1.0 to 12.0.2 fails at DB migration

I have now tried several times to upgrade my DCFM installation from 10.4.5 to 11.1.0 to 12.0.2. There is still a bug in the installer, which runs "df -P" to determine how much space is available. On RHEL5 this leads to not working (it can't grok with the ouput of df havng a K at the end). To work around that I have a script in place which makes sure that df gets called with "df -P -k" which removes the K.

 

After solving that problem I was able to upgrade from 10.4.5 to 11.1.0. The installer for 12.0.2 runs fine through the install also. But when I get to "smc" and the DB migration it starts it, works on it for a couple minutes and then comes back with:

 

Migration failed. Please click Cancel to quit. Your could run the configuration by clicking on /opt/HP_B-series_SAN_Network_Advisor12_0_2/bin/smc

 

If I run smc again, the DB migration immediatly fails. Where can I find a log or debug output to figure out why the DB migration fails?

 

1 REPLY 1
jitter77
Frequent Visitor

Re: Upgrading SAN network advisor from 11.1.0 to 12.0.2 fails at DB migration

Hello UlfZimmermann,

Try to lookup "<installation dir>/logs/cw.log" for more information.
I work for HP.

________________________________________________
// Brocade certified BCFA, BCFP, BCSD, BCSM, BCFD, BCAF