HPE Community
HPE EVA Storage
1753427 Members
4981 Online
108793 Solutions
New Discussion юеВ

Re: View RSS numbers and indexes in Command View

 
SOLVED
Go to solution
Andy Benegas
Advisor

тАО08-19-2009 06:36 AM

тАО08-19-2009 06:36 AM

View RSS numbers and indexes in Command View

We have an EVA4000 firmware version 6.100 and we are using Command View v8.00. We are not able to see the RSS numbers and indexes.

I know that we were able to see the RSS numbers and indexes when the EVA4000 was initially installed. I cannot recall the version of the firmware or Command View.

Is this something that has changed recently?
0 Kudos
3 REPLIES 3
Uwe Zessin
Honored Contributor

тАО08-19-2009 08:23 AM

тАО08-19-2009 08:23 AM

Re: View RSS numbers and indexes in Command View

I still see them in CV 6.0.2, so they must have removed them in 7.0.
.
0 Kudos
Mark...
Honored Contributor

тАО08-20-2009 01:39 AM

тАО08-20-2009 01:39 AM

Solution

Re: View RSS numbers and indexes in Command View

Hi
Yes, the RSS info was removed from the properties of a Vdisk satrting with CV 7.0.
You can still get the info in a few ways.
One is to use SSSU and you can get the info from there. Just do an "ls disk full" if I remember correctly.
Mark...
if you have nothing useful to say, say nothing...
0 Kudos
Andy Benegas
Advisor

тАО08-20-2009 06:14 AM

тАО08-20-2009 06:14 AM

Re: View RSS numbers and indexes in Command View

Thanks for the information. I will give SSSU a try.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.