HPE Community
HPE EVA Storage
1752795 Members
5901 Online
108789 Solutions
New Discussion юеВ

Re: WWN On EVA 6400

 
SupportTeam
Occasional Contributor

тАО03-02-2010 02:00 AM

тАО03-02-2010 02:00 AM

WWN On EVA 6400

I have a recently purchased EVA 6400, putting WWN from OCP, doesn't retain the WWN Name, it zeros out immediately.
what could be the cause of this
0 Kudos
Reply
4 REPLIES 4
Sam Gozin
Occasional Advisor

тАО03-02-2010 05:01 AM

тАО03-02-2010 05:01 AM

Re: WWN On EVA 6400

Is it zeroed out immediately or after a reboot ?

The normal procedure should be :

Enter the WWN and the security code.
Then initialize the EVA from command view and
create a default diskgroup.
If no diskgroup is created the WWN will not be retained.
0 Kudos
Reply
SupportTeam
Occasional Contributor

тАО03-02-2010 06:12 AM

тАО03-02-2010 06:12 AM

Re: WWN On EVA 6400

It zeros out immediately.
0 Kudos
Reply
Torsten.
Acclaimed Contributor

тАО03-02-2010 07:33 AM

тАО03-02-2010 07:33 AM

Re: WWN On EVA 6400

Disks already installed and powered on? Checksum correct?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
chris barnett_2
Frequent Advisor

тАО03-02-2010 07:51 AM

тАО03-02-2010 07:51 AM

Re: WWN On EVA 6400

It's a bug in the XCS code. it should initialize OK from Command View. upgrade it to 09522000. its available from here

https://h20392.www2.hp.com/portal/swdepot/displayProductsList.do?category=NAS

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.