WWN On EVA 6400

 
SupportTeam
Occasional Contributor

WWN On EVA 6400

I have a recently purchased EVA 6400, putting WWN from OCP, doesn't retain the WWN Name, it zeros out immediately.
what could be the cause of this
4 REPLIES 4
Sam Gozin
Occasional Advisor

Re: WWN On EVA 6400

Is it zeroed out immediately or after a reboot ?

The normal procedure should be :

Enter the WWN and the security code.
Then initialize the EVA from command view and
create a default diskgroup.
If no diskgroup is created the WWN will not be retained.
SupportTeam
Occasional Contributor

Re: WWN On EVA 6400

It zeros out immediately.
Torsten.
Acclaimed Contributor

Re: WWN On EVA 6400

Disks already installed and powered on? Checksum correct?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
chris barnett_2
Frequent Advisor

Re: WWN On EVA 6400

It's a bug in the XCS code. it should initialize OK from Command View. upgrade it to 09522000. its available from here

https://h20392.www2.hp.com/portal/swdepot/displayProductsList.do?category=NAS