HPE Community
HPE EVA Storage
1753988 Members
6211 Online
108811 Solutions
New Discussion юеВ

Re: booting problem 4/8 SAN switch

 
michael oticha
Occasional Contributor

тАО07-13-2010 05:11 AM

тАО07-13-2010 05:11 AM

booting problem 4/8 SAN switch

Gurus ,

I have aproblem with 4/8 SAN switch which after I power on and connect to it through the serial connection , I get the attached errors that run nonstop . I will appreciate for any help on this.

Thanks

Michael
0 Kudos
Reply
3 REPLIES 3
Torsten.
Acclaimed Contributor

тАО07-13-2010 05:21 AM

тАО07-13-2010 05:21 AM

Re: booting problem 4/8 SAN switch

If this is the only output you get (can you login?); there is probably nothing you can do - replace.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
michael oticha
Occasional Contributor

тАО07-13-2010 06:15 AM

тАО07-13-2010 06:15 AM

Re: booting problem 4/8 SAN switch

I cannot login at all . I am stuck on this point .
0 Kudos
Reply
Johan Guldmyr
Honored Contributor

тАО07-13-2010 10:25 PM

тАО07-13-2010 10:25 PM

Re: booting problem 4/8 SAN switch

Problem on the I2C bus ouch, doesn't look good at all. Only thing I can think of but it's very far fetched would be to unplug/plug in something in the fc-port.. but it appears that it is rebooting even before the fc ports are initialized so probably won't change anything..

Replace :/
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.