HPE EVA Storage
1748169 Members
4324 Online
108758 Solutions
New Discussion юеВ

Re: "protection failure"

 
ess
Super Advisor

"protection failure"

Hi All
Please say my what is "protection failure" level in eva?
tanks for help.
5 REPLIES 5
Prakash Singh_1
HPE Pro

Re: "protection failure"

In a Disk group "Protection level" is actually called Disk Group Failure Protection level used to sustain 0,1 or 2 drive failures.

This can be done by selecting none, single or Double options Under Dikgroup general tab in comman view eva.

You can also chk this post for more clarification.

http://forums11.itrc.hp.com/service/forums/questionanswer.do?threadId=1000778

Regards,

Prakash
Regards,

PS
To assign points on this post? Click the white Thumbs up below!
hvhari
Esteemed Contributor

Re: "protection failure"

Hi ESS,

Following HP document should explain you abou this.

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&objectID=c01209515&prodTypeId=12169&prodSeriesId=3664763

Protection Level: The EVA has three protection levels: 0, 1, and 2. The number represents the guaranteed number of disks that can be reconstructed after disk(s) failure. This is accomplished by setting aside (reserving) enough capacity for the reconstruction to complete.

Regards,
Hari

If this post was useful , click the Kudos Star on the left side to say Thanks!
hvhari
Esteemed Contributor

Re: "protection failure"

please let me know if this was helpful.
Regards,
Hari

If this post was useful , click the Kudos Star on the left side to say Thanks!
ess
Super Advisor

Re: "protection failure"

Hi
tanks for help.your answer not bad.if any document of hp please send my.
tanks.
hvhari
Esteemed Contributor

Re: "protection failure"

my previous posting is an HP guide explaining this.

Note:please do not forget to assign points if the response helps you.
Regards,
Hari

If this post was useful , click the Kudos Star on the left side to say Thanks!