Nimble IQN

[PeterVoigt]

Hi

I want to boot from my servers directly from a Nimble volume via iSCSI. On the volume I can see the IQN for the specific volume, but since I have a lot off servers cant I just add the IQN for the array and set up access control to each volume instead. I'm going to setup the access control anyway.

Where do I find the IQN for the array ?

Thx

Peter

[Josh94K]

Hello, @PeterVoigt  Hope you are doing well. !

iSCSI Qualified Name (IQN)
The IQN is available only for the volumes and not for the array. 

Additional Information
You can also refer to the following conversations/Links for additional information. 

https://community.hpe.com/t5/Array-Setup-and-Networking/Has-anyone-done-Windows-2008-R2-boot-from-Nimble-via-iSCSI/td-p/6984664

https://infosight.hpe.com/InfoSight/media/cms/active/public/pubs_Windows_Integration_Guide_NWT_5_0_0.whz/tij1480982975455.html

should you need additional assistance you can always get in touch with : support@nimblestorage.com / HPE support

@PeterVoigt   I hope this helps! 
If you feel this was helpful, Please HIT that KUDOS!  thumb below!

Note: "While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company."