- Community Home
- >
- Software
- >
- HPE OneView
- >
- After changing IP address of HPE OneView 3.0 appli...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-02-2018 03:48 PM
05-02-2018 03:48 PM
After changing IP address of HPE OneView 3.0 appliance iLO becomes unreachable
Hi,
I had to change our HPE OneView appliance's IPv4 for a new address in a more secure subnet. Eventhough there are no firewalls and nothing that stops me from pulling data from iLO, I lost connection to all my iLO cards. If I remove a server and try to add the server hardware again, the iLO remains ureachable. Should I consider deleting the HPEOneView user on each iLO card and remove the old address of the appliance in the SNMP settings? Or is there an easier way out.
Thank you for your help.
Best regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-21-2018 05:55 PM
05-21-2018 05:55 PM
Re: After changing IP address of HPE OneView 3.0 appliance iLO becomes unreachable
If you have not yet resolved this, check to make sure you supplied the right subnet mask, default gateway, and that you can route from the new subnet to the old one where your iLO's reside. Next, check to see if any firewalls are blocking required TCP ports needed to manage a server via the iLO. Required TCP ports are documented in Online Help and the User Guide.
I am an HPE employee