HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
HPE OneView
cancel
Showing results for 
Search instead for 
Did you mean: 

Change c7000 oa Ip address and name

 
MeFromil
Advisor

Change c7000 oa Ip address and name

hi 

i would like to change the oa ip address and name of c7000 

any best practice for it ? 

 

 

4 REPLIES
ChrisLynchHPE
Neighborhood Moderator

Re: Change c7000 oa Ip address and name

If you added your enclosure with a Fully Qualified Domain Name (FQDN) instead of its IP Address, then go modify the IPv4 Address and OA name in the OA UI or CLI.  Then, go back to OneView, perform a refresh of the Enclosure.  You may be prompted for the hostname and credentials again.  Once that refresh finishes successfully, then that is it.

MeFromil
Advisor

Re: Change c7000 oa Ip address and name

i didnt config it with FQDN 

 

skins4ev4
Occasional Visitor

Re: Change c7000 oa Ip address and name

If I recall, the process is to change the secondary OA IP first, roll over to it and then the primary.  I didn't do this and had to open a case to get the OneView appliance to update the referenced IPs from the engineering console.

rohw
Advisor

Re: Change c7000 oa Ip address and name

The only problem we ran into was DNS.  After changing the IP address for both OAs OneView would not refresh the enclosure.  After the DNS records were fixed, it refreshed with no issues.