HPE OneView
1748102 Members
4779 Online
108758 Solutions
New Discussion

HPE OneView for VMware vcenter version 8.0 and Storage Plugin with 3Par Support

 
paolo marin
Occasional Advisor

HPE OneView for VMware vcenter version 8.0 and Storage Plugin with 3Par Support

I have installed and configured the HPE OneView for VMware vcenter appliance version 8.0

The issue that I am experiencing is when I am adding the 3PAR StoreServ the Model and Firmware are "blank" .

The 3PAR credential and dns anme are correct and certificate is correct.

Please advice.

Thanks

 

Kind regards

Paolo Marin
4 REPLIES 4
paolo marin
Occasional Advisor

Re: HPE OneView for VMware vcenter version 8.0

From the vcenetr point of view I cannot see the properties of the array, not avaiable.

see attached.

I have restarted the CIM on the 3par array with no results

 

Anyone experienced this issue?

Kind regards

Paolo Marin
ChrisLynch
HPE Pro

Re: HPE OneView for VMware vcenter version 8.0

What 3PAR firmware version do you have on your storage system?  You may have a newer version that the vCenter Plugin does not support yet.


I am an HPE employee

Accept or Kudo

paolo marin
Occasional Advisor

Re: HPE OneView for VMware vcenter version 8.0

Sorry for the late reply.

OS 3.2.2 - MU2 (patch up to P33)

Kind regards

Paolo Marin
Edward L. Haletky
Valued Contributor

Re: HPE OneView for VMware vcenter version 8.0

Hello,

Are you using a separate network for the 3Par management layer? Or is it the same management network as ESXi and OV4VC? I tried routing everything through a gateway to gain access to my storage and it would not work either. OV4VC had to be on the same network as my storage device. I also made sure that 2nd NIC was marked as Management.

Best regards,

Edward Haletky