HPE OneView
cancel
Showing results for 
Search instead for 
Did you mean: 

OneView 1.1, VC Flex10D & VC FC (8gb 20port) Stuck Adding VC FC Modules

Poyatier
Occasional Collector

OneView 1.1, VC Flex10D & VC FC (8gb 20port) Stuck Adding VC FC Modules

Greetings--

 

Have downloaded the long-awaited 1.1 appliance for the VC FC Module support and am attempting to import a new/clean enclosure that contains 2 x VC Flex10-10D Modules and 2 x VC FC 8GB 20Port Modules.

 

Enclosure and Flex10Ds import fine; however, after about 3 minutes the VC FC Module imports fail, saying interconnect response time-out.  Interconnect could not be brought under management.

 

Now the modules are stuck in a state of Adding.

 

Have tried powering off all the modules, clearing VC from the OAs, verifying I can ping the VC FC module IPs, removing & readding the enclosure, and manually verifying firmware is updated everywhere.

 

Anyone have any thoughts before I go and open a support case with HP?

 

Thanks!

1 REPLY
Poyatier
Occasional Collector

Re: OneView 1.1, VC Flex10D & VC FC (8gb 20port) Stuck Adding VC FC Modules

Followup for anyone else...

 

We opened a case and after getting escelated, we got the problem resolved.  The solution, as with everything (and of course it was so obvious we didn't try it)... was to simply reboot the OneView appliance.