- Community Home
- >
- Software
- >
- HPE OneView
- >
- Re: unable to update profile after SUT
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО01-31-2019 05:34 AM
тАО01-31-2019 05:34 AM
unable to update profile after SUT
After i installed SUT and configured it with SUT /set mode=AutoDeployReboot i set a Driver and Firmware update via Smarttools in OV. that seems to work fine, but after the reboot i cannot update the profile anymore ( i want to remove the baseline as deployment is completed, from wha i see with /status). See error message
any clue other then power down and update the profile? and 2nd is this a normal behaviour?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО02-04-2019 09:00 PM
тАО02-04-2019 09:00 PM
Re: unable to update profile after SUT
Hi,
Good Day!
I wouls suggest you to power off the server and then update the server profile and check for the reported issue.
Cheers
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО02-05-2019 12:18 AM
тАО02-05-2019 12:18 AM
Re: unable to update profile after SUT
Yes well that i wanted to avoid :) to take it down again. most likely that will solve the problem but i would like to know if this is a normal behaviour as this is a pilot deployment.