Autobalancer degrated : - dsv-balance-show --status

[jneau]

Hello,
In a stretched cluster of 4 nodes in version 4.1.0U1 build 4.1.0.284, updated 2 months ago.
The Vms are correctly protected by the HA (primary/secondary). Passing the dsv-balance-show –status command, we see that two nodes are reporting errors in the “autobalancer status table” table at the “misfit migrator” parameter is Unbalanced and Degraded on two out of four nodes.
We executed the commands “dsv-balance-disable” then “dsv-balance-enable” (with a 5 min pause between the two commands), the result is the same.
Thanks for your feedback,
Have a good day,
Julian,

[sbhat09]

Hello @jneau,

Can you please share the error message or screenshot here?

Regards,
Srinivas Bhat

If you feel this was helpful please click the KUDOS! thumb below!
Note: All of my comments are my own and are not any official representation of the company.

[jneau]

Hello,

Thank for reply,

Below are the screenshots.

Best Regards,

Julian,

[Mahesh202 · Accepted solution]

Hi jneau

"The two nodes that are reporting errors in the “autobalancer status table” table at the “misfit migrator” parameter is Unbalanced and Degraded on two out of four nodes" as shown is actually not an error you may Ignore this because this may be a misreporting error.

However, I suggest you to update it to the latest build version 4.1.1 at the earliest to fix this.

Hope this helps.!!

Regards
Mahesh

[jneau]

Hello,
Thank you for your winning feedback!!
This community is very valuable.
Very good day.
Julian,