Community
HPE SimpliVity
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Re: How to run a health check on Simplivity Cluster?

 
SOLVED
Go to solution
AshruTech
Occasional Contributor

a month ago

a month ago

How to run a health check on Simplivity Cluster?

Dear All,

How to run a health check on Simplivity Cluster?

If I restart any SimpliVity node after restart How can I  verify simplicity node is working fine?

If a network connectivity issue happed then restoredHow can I  verify simplicity node is working fine?

 

 

0 Kudos
Reply
1 REPLY 1
Randolfini
Advisor

a month ago

a month ago

Solution

Re: How to run a health check on Simplivity Cluster?

Hi Ashru Tech,

You can SSH to the Omnistack Virtual Controller, authenticate as a vCenter administrator, then you can run the following commands:

svt-federation-show           If the output shows the nodes Connected and Alive then the cluster federation is healthy.

svt-vm-show --violations         If the output doesn't show any VMs in violation of storage HA then storage HA is healthy.

Those are the general commands to use to check on health.

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.