HPE StoreVirtual Storage / LeftHand
cancel
Showing results for 
Search instead for 
Did you mean: 

Attached error messages after performing a NIC Bond....any idea

jackblackattack
Occasional Contributor

Attached error messages after performing a NIC Bond....any idea

I went ahead and createan ALB NIC bond I can't tell if it's sucessful based on these warning messages?

 

Any advice?

2 REPLIES
Emilo
Trusted Contributor

Re: Attached error messages after performing a NIC Bond....any idea

It looks like you have the either the 2nd NIC not plugged in or the port is not on.

Before you create the bond you need to make sure they are both lit up.

You will need ot assign each a IP address , one is only temporty so configure the optional settings (flow control, mtu etc)

Once you make sure you have the NIC's lit up then you make the bond.

 

 

Emilo
Trusted Contributor

Re: Attached error messages after performing a NIC Bond....any idea

OH and 1 more thing make sure you dont add a 2nd gateway to the 2nd NIC before the bond.

 

NIC1 should have everyting

NIC 2 should be the same except no Gateway.