- Community Home
- >
- Storage
- >
- Midrange and Enterprise Storage
- >
- StoreVirtual Storage
- >
- CMC installation on Accelerated iSCSI
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-22-2012 08:25 AM - edited 10-22-2012 09:09 AM
10-22-2012 08:25 AM - edited 10-22-2012 09:09 AM
CMC installation on Accelerated iSCSI
Hi
I have an windows Hyper-V server connected to P4000 and I installed on this server CMC for managing the P4000 but the installation does not find the P4000 IP addresses as the server Iscsi is hardware defined (Accelerated iSCSI) and it does not appear as a network card but as an HBA I also have a problem of installing FOM on this server for the same reason. The server is connected to virtual connect. Has anybody worked in this way. Any help would be appreciated.
Regards
- Tags:
- Hyper-V
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-05-2013 01:37 AM
03-05-2013 01:37 AM
Re: CMC installation on Accelerated iSCSI
Hello! I have similiar problem with Qlogiq iSCSI HBA in blade servers. Support can't help me. I think Leftahand can't make normal work with accelerated iSCSI
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-05-2013 06:52 PM
03-05-2013 06:52 PM
Re: CMC installation on Accelerated iSCSI
The answer to this one is relatively simple - the CMC needs IP connectivity to the SAN - so make the traffic routable to and from the SAN and the CMC.
Qlogic cards are not NICs so you are not going to get through that way...
So if you have the SAN on vlan 101 and the CMC on vlan 100 you are going to need to setup a gateway router on both VLANs.
This is probably necessary anyway to allow the units to get to the SMTP server...
Good luck.
David Tocker