Configuration Mail on P4500 with another network

[Fableo]

Hello,

I have a network 10.1.1.X for SAN and network 172.16.xx for LAN.
I would like to configure the email on the P4500 but my SMTP server in the network 172.16.xx CMC does not want my address 172.16.X.X
How do I do? :smileysurprised:

[Bart_Heungens]

Hi,

There are several ways, it depends of what is allowed within your company...

You will need to setup routing between those 2 networks... Often this is done by 1 of the 'SAN' switches (which are off course LAN switches) which will be connected with a physical cable to the regular LAN switches, with our without VLAN's (my experience around me: with VLAN's)

I have seen also solutions where the mail server is a VM running on the ESX servers which have a connection to the P4500... In that case you can connect an additional interface to the ESX server and connect it inside the 10.1.1.x network...

Kr,

Bart

[Fableo]

Not fool the second solution. :smileywink:

I will activate a relay SMTP on an exchange HUB/CAS in the 10.1.1.X network

[Bart_Heungens · Accepted solution]

You're welcome...

If this is a valid solution, do not to forget to set this also in the forums for other visitors...

Kr,

Bart

[Fableo]

I have configured the relay SMTP on the Hub/CAS with the network 10.1.1.X.
The test is ok.
Thanks

[Bart_Heungens]

Perfect, good to hear!

Kr,

Bart