HPE StoreVirtual Storage / LeftHand
cancel
Showing results for 
Search instead for 
Did you mean: 

Multi-site SAN with only 10MB connection

SOLVED
Go to solution
AB_1234
Occasional Contributor

Multi-site SAN with only 10MB connection

Hi Guys, 

I need a little help,

 

I have 2 P4500 with total 4 nodes, 2 nodes at main site and 2 at DR site, I need to make a replication between main and DR site, and the connection is only one link with 10MB between the sites

 

so what is the best option here:

 

Multisite SAN configuration with Raid-10 (synchronous): will it be ok to use 10MB network link between the 2 sites? - more preferred

 

or make a remote copy (asynchronous), can we make the remote copy every 10min, i tried but it did not  work, any idea how can make it work - if it is possible?


regards,

 

4 REPLIES
Dirk Trilsbeek
Valued Contributor
Solution

Re: Multi-site SAN with only 10MB connection

a multisite-san with only 10 MBit bandwith would be incredibly slow on writes and during resync, not to mention the response time, which would probably be too high for a multisite-san. I'd go for the replication.

Bart_Heungens
Honored Contributor

Re: Multi-site SAN with only 10MB connection

Hi,

 

This will not work (well)... You shoud count for 50 MBps per 2 nodes... In your case I should go for a 2Gbps connection...

 

So I would go for the asynchronous solution...

 

Kr,

Bart

--------------------------------------------------------------------------------
If my post was useful, clik on my KUDOS! "White Star" !
My blog: http://blog.bitcon.be
AB_1234
Occasional Contributor

Re: Multi-site SAN with only 10MB connection

Thank you Guys, 

 

i manage to do the async already, but 10min will not work with P4000, you need to use 30min as a minimum for each snapshot taken.

 

Thank you Bart :) .. 

 

 

bryan_hadzik
Frequent Advisor

Re: Multi-site SAN with only 10MB connection

The other guys are right about why not to do it, but I thought I would explain in detail a little more. When setup in multi-site, if you use network raid 10, we have to write the block to both sides. We don't tell the server the block is completed writing until both sides have it. You could write it to the local side very quickly, but if the latency to the other site is over 2ms, it would start to slow everything down, even on the local side. Latency is sometimes more of a barrier than bandwidth.