HPE StoreVirtual Storage / LeftHand
cancel
Showing results for 
Search instead for 
Did you mean: 

P4800 Blades issue

SOLVED
Go to solution
shariqMCS08
Occasional Contributor

P4800 Blades issue

Hi,

 

Have  a c7000 with bl460-g7 blades setup. Bays 7-8 and 15-16 have p4800. Issue not being able to power up the bl460’s. the p4800 blades can be powered up well.

We have tried going into the OA, tried ILO webpage and powering up. Power source is ok.
Cannot power up blades with or without profiles. Have shutdown the 4 p4800’s and tried powering up. Startup sequence has been set to disabled on the blades. There is no power limit set. Next thing would try is power down the enclosure.

Has anyone seen this type of issue??

 

Cheerz

2 REPLIES

Re: P4800 Blades issue

If you select one of the blades with the ‘I’, what does it indicate as the problem?
Set the ‘Power On delay’ feature? and verify if these have the power on disabled?
Are there other types of MEZZ cards in the slot 2?

This should cause a red condition.
Can the site supply the ‘Show all’ script?
What version is the OA and VC?

Regards,

PS
To assign points on this post? Click the white Thumbs up below!
Solution

Re: P4800 Blades issue

You can also Try SSH/Telnet in to the OA and run RESET SERVER X which resets almost everything that a blade reseat would.

 

 

 

Regards,

PS
To assign points on this post? Click the white Thumbs up below!