StoreVirtual Storage
1748185 Members
4178 Online
108759 Solutions
New Discussion

VSA on ESXi with SSD and SAS

 
SOLVED
Go to solution
Panzer_1
Frequent Advisor

VSA on ESXi with SSD and SAS

I am new to VSA and need some info on disk configuration. I have 2 nodes, both with 4xSSD and 8xSAS-drives. ESXi will be installed on a flash card. Please let me know if I have got this right:

Install ESXi on flash card

Configure 2 arrays on each node. Should I use RAID1 on the the 4 SSD drives and RAID5 on the SAS drives?

Install VSA from ovf-image and store it on the SAS-array

Configure 2 datastores with Network Raid 10, one with SSD and one with SAS

Is this correct? If yes, how do I configure Adaptive Optimization?

 

1 REPLY 1
giladzzz
Honored Contributor
Solution

Re: VSA on ESXi with SSD and SAS

Hi

1) Install EXSI on flash card

2) configure array of SAS with 2 logical drives a small logical drive for the VSA guest ( 100GB or less) to act as local Datastore and the rest for "shared storage"

3) configure array of SSD drives can be raid 5

4) install VSA on ESXI using the SSD (tier 0) and SAS (tier 1) as storage for the VSA so you will be able to use adaptive optimization (also it is good to use the stoarage of the VSA as RDM drives so you will not see them as datastores)

to enable local disks as RDM goto configuration > software > advanced settings > remove V from RdmFilter.

5) do the same on the other ESX node

6) create Storevirtual cluster and export Datastore as shared storage for your VMware cluster 

Adaptive optimization is enabled by default if your VSA has 2 tiers.

Regards

 

Give a Kudo if this helps