monitoring hardware with snmp (p4500)

[basdejongg]

hello all,

i am trying to monitor hardware from my p4500 with snmp get.

some functions i managed to find, the following functions i could not find.

is there anyone who can help me find OID's ??

Disk status(each disk seperate) - -  Failed or OK

network status -- Linked or not

network status -- current speed

network status -- dubplex full or half

network status -- bandwidth

Volume -- IO latency

Volume -- throughput

Volume -- Free space

With friendly greets

Bas de Jong

bas@dejong.pro

[Gediminas Vilutis]

What monitoring system are you using?

Gediminas

[basdejongg]

Hello, 

sorry for the delay.

i am using frameflow / tembria.

it can monitor on OID's 

i got some monitoris working, and also from other devices such as UPS systems, Nas systems.

could u help me??

[Gediminas Vilutis]

For LH specific oids you can check HP document - http://h10032.www1.hp.com/ctg/Manual/c01750818.pdf

But keep in mind - table at the end of document is not correct, always check MIB file for correct values.

Gediminas

[basdejongg]

When I scan the device, I cannot see any oid's for the lefthand part, its like, it is not there.

Now I read somewhere that I have to add the mib's to a specific folder on the root of the p4500.

the only problem is, that  I have no idea how to do this,

can I log into it with scp  as root or???

With friendly Greets

Bas

[ryan_1212]

Do not have to configure anything on the nodes themselves, except in the CMC you have to turn on a community string, etc so it can authenticate to read values.

[Emilo]

When you install the CMC software make sure you do a complete install not typical it should install all the agents then.