- Community Home
- >
- Servers and Operating Systems
- >
- HPE Synergy
- >
- HPE Synergy
- >
- Re: Specifying a IP range for OneView setup
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-30-2021 12:18 PM
03-30-2021 12:18 PM
Specifying a IP range for OneView setup
Is there a way other than subnet masking to set a IP range for OneView? I have a few OneView instances that are class B networks and each instance will consume less than 100 IP addresses. The smallest subnet setting I see is 512 ip addresses.
Thanks, Dave
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-30-2021 02:18 PM
03-30-2021 02:18 PM
Re: Specifying a IP range for OneView setup
Keep in mind that the subnet ranges are applicable only to the local HPE Synergy ring. There are a maximum of 21 frames, each containing a maximum of 12 compute and 6 fabric modules. So, that means roughly 378 IP addresses would be needed for just 1 IPv4 or IPv6 Subnet. That assumes no Image Streamer configuration BTW.
As for configuring, that is all dependant upon you and what you need to allocate. Not everyone can allocate concurrent IP ranges. You define a Subnet, with the appropriate subnet mask, then include IP's within a range. The IP's you specify cannot go beyond the subnet mask you define within the Subnet resource. And really, we are talking about classless address configuration here. So, the fact you have a Class B has nothing to do with configuring the IPv4 Subnet.
I am an HPE employee