- Community Home
- >
- Servers and Operating Systems
- >
- HPE Synergy
- >
- HPE Synergy
- >
- Unable to open compute module consoles on two blad...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-06-2021 10:39 AM - last edited on 10-06-2021 08:53 PM by support_s
10-06-2021 10:39 AM - last edited on 10-06-2021 08:53 PM by support_s
Unable to open compute module consoles on two blades using OneView
After moving our one of our Synergy installation to a new network, we are unable to start console for two from OneView. We see a message saying "Connected" and no further output. We have physically reset both of the compute modules and that did not help. We need to get into the console in order change the IP address of the iLO. What can we do to poke the blades to open up the console?
Dave
- Tags:
- iLO_OA
- Synergy system
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-06-2021 10:43 AM - edited 10-06-2021 10:45 AM
10-06-2021 10:43 AM - edited 10-06-2021 10:45 AM
Re: Unable to open compute module consoles on two blades using OneView
In Synergy, from OneView hardware there is an IPv4 address, IPv6 address, and DNS name with SSO. You should be able to get there through one of those links without ever opening up a console.
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]