- Community Home
- >
- Networking
- >
- IMC
- >
- Changing many switch baselines?
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-05-2016 12:05 PM
04-05-2016 12:05 PM
Changing many switch baselines?
Thanks to previous responses, I know how to go to each switch and change a baseline for each swtich one at a time. But if I do a image upgrade, the audit baseline will show a difference with simply an acknowledgment of the new OS level. If I do this for over 100 switches, it becomes painful to go one by one to establish the new baseline.
So, is it possible to baseline many switches/devices at a time? After all, if I look at the audit before doing a bunch of updates and then again after I do a bunch of updates, I am pretty sure the differences are due to my actions and not a hacker. It would save me a lot of time if I could re-baseline in mass as opposed to one at a time.
Tim
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-09-2017 07:06 AM
08-09-2017 07:06 AM
Re: Changing many switch baselines?
Tim,
I am looking to do exactly this - did you manage to find the solution or has anyone else found a way to do this. Seems like something you should be able to do en-masse after an upgrade.
Regards
Mike
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-09-2017 07:25 AM
08-09-2017 07:25 AM
Re: Changing many switch baselines?
Finally managed to find out how to do this though it was not intuitive :0)
You need to go to Configuration Center, Software Library,
Select the release you want, Under operation select Make Baseline
From there you can either apply to one or more devices or based on model (which is more likely)
Regards
Mike