HPE IMC 7.2 / Config-Backup from 2920-Stack

[ley_1]

hi@all

I have a problem with a 2920 stack / IMC Backup run/startupconfig.

(WB.15.18.0007)
I do not get a backup of the startup / runconfig from the switch.
Snmp / telnet accesses and tested.

Does one know the problem?

[LindsayHill]

Like the message says, Login Type is set to None.

Just picking a template alone is not enough. On the Device Details page, there's a Login type drop-down box, where you can choose SSH, Telnet or None. Set it to Telnet.

[ley_1]

Hi,

i Have a Template (SW_Telnet) and this its ok (2016-11-30 12_46_06-Mozilla Firefox.jpg ‏15 KB)

With all other Switche it is, only the stack makes problems

tom

[ley_1]

Hi@all,

i have del the device and have a new import

(temp. it the same)

and.... all ok, backup ok,

:-)

Do not know why, but it goes
Merry Christmas

[LindsayHill]

It works this time because when you recreated the device, you set the Login Type to Telnet. (It might even be the default, I don't recall).

All you had to do was change the Login Type. You didn't need to delete the device. The Template by itself doesn't set the login type.