- Community Home
- >
- Networking
- >
- IMC
- >
- Re: Hardware monitoring
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-13-2018 05:43 AM
04-13-2018 05:43 AM
Hardware monitoring
how to configure HPE IMC to monitor SW modules and power supply, POE fault errors.
On SWs are configured SNMPv3
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-13-2018 01:54 PM
04-13-2018 01:54 PM
Re: Hardware monitoring
You will need to enable traps on the device and configure IMC as a trap receiver . The POE, PSU failure alarms etc are sent as traps to IMC from the device.
I am an HPE employee
-------------------------------------------------------------------------
Was the post useful? Click on Kudos Thumb below
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-16-2018 05:47 AM
04-16-2018 05:47 AM
Re: Hardware monitoring
can you please provide some example let say for SW 5406Rzl2 J9850A and IMC version 7.2
i was trying to configure on IMC syslog templates, buti thing this thing depends on severity on devices.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-16-2018 12:43 PM
04-16-2018 12:43 PM
Re: Hardware monitoring
IMC should already have the trap configurations in place on the server side, for HPE switches. You just need to add the trap destinations to the switches.