IMC
cancel
Showing results for 
Search instead for 
Did you mean: 

IMC Notification via eMail ... direction interface lower/greater than the baseline

Kal_el
Occasional Collector

IMC Notification via eMail ... direction interface lower/greater than the baseline

Hello,

 

iMC is sending this kind of message via eMail and I want to reconfigure the baselines (lower and grater)....

 

 

The [in][out] direction of interface [#] on device [#.#.#.#]  at  [Date] [Hour] is [lower][grater] than the baseline(#.## Gbps).

 

 

my intention is to change the default configuration and costumize it on the iMC.

 

 

 

On which module can I change the config?...

 

 

¿Is it possible?

 

 

Regards.

2 REPLIES
MohammadH
Regular Advisor

Re: IMC Notification via eMail ... direction interface lower/greater than the baseline

Hello

did you solve this problem ? i have same problem.

NeilR
Respected Contributor

Re: IMC Notification via eMail ... direction interface lower/greater than the baseline

The baseline is an option in the NTA - traffic analysis module under Service > Settings > Traffic Analysis Task Management

the baseline is an on/off option - It calculates the baseline based on prior utilization as some kind of rolling average, and I don't think you can set a value for it. So if you have interfaces with a lot of variability the baseline notification gets a bit annoying - it works better for more constant flows.

There is also the threshold option which can be configured both for individual nodes and as a global value under resource > monitoring settings