IMC
cancel
Showing results for 
Search instead for 
Did you mean: 

Need help using Batch Operation to Set Trap Destination

SOLVED
Go to solution
John H. Miller
Occasional Advisor

Need help using Batch Operation to Set Trap Destination

iMC ver 7.2 I need to set up a trap destination in several switches and Batch Mode seems to be the answer. However, I need the events to be ALL, but the batch operation sets it to NONE. Is there a way to change that or am I back to manually setting this up? OR...is there a way to create my own batch commands as there was in PCM?

Thanks - John Miller

2 REPLIES
LindsayHill
Honored Contributor
Solution

Re: Need help using Batch Operation to Set Trap Destination

Yes, you can easily push out your own set of commands. Check out the "Configuration and Change Management" section of the Admin Guide.

John H. Miller
Occasional Advisor

Re: Need help using Batch Operation to Set Trap Destination

Great! Found the procedure and it worked great! Thanks so much! - John