1748157 Members
4093 Online
108758 Solutions
New Discussion

Re: Power over ethernet alarm for IMC

 
YenLin
Frequent Advisor

Power over ethernet alarm for IMC

Hi all,

we've got a lot of error messages from our POE switches on iMC.

 

For example: The status of THE PSE Port(1,19) is 6 (1 disabled, 2 searching, 3 deliveringPower, 4 fault, 5 test, 6 otherFault).

However, when I checked the switch's configuration.

Both port of 1 and 19 are all disable poweroverethernet.(Command:no power-over-ethernet)

 

There are also a lot of other switches showing other message which is incorrect.

 

Is there any method that can create a remedy/recover policy to automatically fix this alarm?

1 REPLY 1
LindsayHill
Honored Contributor

Re: Power over ethernet alarm for IMC

You can filter alarms if you don't want them. When looking at the alarm details, there should be an option to filter them on a per device or global basis.

 

Before doing that, it might be worth digging in a bit deeper to see exactly where the alarm's coming from.