IMC
cancel
Showing results for 
Search instead for 
Did you mean: 

Setting up TAM, I keep getting this error and I don't know why. So frustrating.

Dape_
Occasional Contributor

Setting up TAM, I keep getting this error and I don't know why. So frustrating.

Hello,

 

I have installed the TACACS+ module for IMC and I have everything setup from what I can tell.  When I try to log on to a switch by using TACACS+ from IMC, I get access denied.  Looking at the IMC log, this is the error message I get.

 

hpTAMscreenshot.JPG

 

Does anyone know why this keeps happening?  Thanks in advance for any help you can offer.  

 

 

2 REPLIES
Lynn-Marie
Neighborhood Admin

Re: Setting up TAM, I keep getting this error and I don't know why. So frustrating.

Did you ever figure out what was going on? At the risk of asking the obvious, is there an RSA configuration set somewhere within the module?

 

If you still need help, I will flag down one of our TAM experts to help you.

 

Kind regards,

Lynn-Marie

Neelixx
Frequent Advisor

Re: Setting up TAM, I keep getting this error and I don't know why. So frustrating.

I use TAM, but not much on HP switches.  Deployed using Authentication for Juniper's until HP can give me vendor specific attributes, and some Cisco. 

 

I have a few HP switches that I need to have setup.  Is this on an HP switch?  If so, what kind?  I'll see if I can replicate it, since I need to set it up anyway.

 

-------
Aaron Paxson
@Neelixx