IMC
cancel
Showing results for 
Search instead for 
Did you mean: 

Trial Installation of IMC 7.2 - no Topology Views...

 
MMeroth
Visitor

Trial Installation of IMC 7.2 - no Topology Views...

Hello Community!

We have installed here in our german office about 30 HP ProLiant servers an 10 HP ProCurve switches. We are looking for an Software Solution to manage these nodes. In our Trial Installation of the IMC v7.2 everything looks like fine except the Topology Views under Resource and Custom View... We only get an grey windows without any Icons, Menues, Nodes, etc... We have tested it with varios Browsers such as FF, IE and Chrome. The imcl2topodm Process on the ICM Server is running... Without this function, the software is not useful for us.

 

Thank you for your support.

Best regards Mike Meroth

 
 
 
 
3 REPLIES
NeilR
Respected Contributor

Re: Trial Installation of IMC 7.2 - no Topology Views...

Mike,

I can confirm that the topology views should display, even if imcl2topodm process is stopped, so some other issue must be affecting this.

You may have tried, but did you try accessing topology from other ways?

- If you select network topology under view management (instead of in custom views), a new browser window or tab should open - was there any success under custom or IP topology there?

 

MMeroth
Visitor

Re: Trial Installation of IMC 7.2 - no Topology Views...

Hello neil, Thank you for your answer, yes we have tried all other possibilities. The problem also occurs when we start the custom views topology views. Many greetings mike
system2
Visitor

Re: Trial Installation of IMC 7.2 - no Topology Views...

Had the same problem when trying to get access to server by entering his address in browser (192.168.0.10:8080 for example) on PC in the same network. I fixed it by entering IMC web interface from the server itself by entering in browser localhost:8080.