Which port should we send netflow data in HP IMC

[nithish4u]

HI,

I have some cisco ISR where i enabled netflow. Can anyone guide me to which port can i send the traffic, so that i can view those in my dashboard.

The help guide is of no use for Net flow. Any step by step proceedure would be apreciated.

Regards,

Nithish.

[Neelixx]

After you deploy and setup your NTA, the default port is 9996.

[nithish4u]

Hi Aaron,

Thanks for your reply, also addtionally do i need to configure anything on NTA server? If i just send traffic to NTA server  to port number 9996, would this populate data in my server. 

Thanks,

Nithish.

[Neelixx]

NTA can be fairly DiskIO and CPU intensive, depending on how many devices and flows it has to go through.  Most people setup a seperate NTA box.  But, it can run on the same box as iMC.

Check out Chris Young's video:  http://www.youtube.com/watch?v=-TG8fpbxRv8

Or, I wrote up a how to for Juniper.  But, steps 1-7 show the setup for iMC: http://www.netopscommunity.net/knowledge-center/-/wiki/Main/Configure+Juniper+SFlow+for+HP+iMC