IMC
cancel
Showing results for 
Search instead for 
Did you mean: 

snmp trap (power supply event) not showing in trap browser

Nicolas_M1
Occasional Visitor

snmp trap (power supply event) not showing in trap browser

Hello,

We have a HP A7506 in our network and like to know if a power supply fail.

We tried to turn off one of them. 

We can see the trap with wireshark but nothing shows up in the trap browser. I already disabled the "unknown trap filter"

1.PNG

Do I need to add a mib to see the trap in the interface ?

1 REPLY
RPapaux
Frequent Advisor

Re: snmp trap (power supply event) not showing in trap browser

Hi,

Go to Alarm -> Trap Management -> Trap Definition.

In the search window look for the trap OID: 1.3.6.1.4.1.25506.8.35.

You should see a number of traps in relation with power supplies, temperature, etc, icluding yours.

Ensure that the trap has a sverity enough to appear in your browser (indeed higher then INFO).

If they are not there load the "H3C Ethernet Switch" trap MIB file (avaialble on HPE site)

then;

Go to Alarm -> Trap Management -> Trap to Alarm

Ensure that the "H3C Ethernet Switch" is ENABLE with default rule.

You might have another issue, but al least this is worth to check.

Cheers

Ray