- Community Home
- >
- Networking
- >
- Legacy
- >
- IP Telephony - NBX
- >
- strange call pickup issue
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-21-2013 08:14 PM
02-21-2013 08:14 PM
Have NBX with 4 port analog card and four lines plugged in. The lines are four pin phone cables that come from RJ11 jacks connected to 66block that amphenol from providers router is punched in. These are voip lines setup for loop start. NBX works for first couple of incoming or outgoing calls then rings busy. Provider changed something on their side and now, instead of ringing busy, there is a short ring and silence.
Service providers debugger tells that, when called on one line, NBX picks up two lines at once and that causes the issue.
Disconnected one of the lines from NBX and connected to analog phone, and analog phone works fine.
Moved the lines to another 4 port analog card on the same NBX and it worked fine for a couple of calls then run into same issue.
I dont see any configuration errors on NBX. I am not sure if the wall jacks are wired for two or four pin. Will try to find out. Will the 4 pin phone cables cause this issue?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-22-2013 11:35 AM