HPE Community
Operating System - HP-UX
1753649 Members
6107 Online
108798 Solutions
New Discussion

Re: Clone B2600 System to C3600

 
efirkey
Advisor

‎01-24-2014 08:55 AM - last edited on ‎01-25-2014 05:08 PM by

‎01-24-2014 08:55 AM - last edited on ‎01-25-2014 05:08 PM by

Clone B2600 System to C3600

Is it possible to use an ignite backup image to copy my entire B2600 system to a C3600 workstation?  I have tried and run into issues with the machine paths not being the same.

 

Thank you.

 

 

P.S. This thread has been moved from Workstations - Itanium-Based, hp9000, Visualize to HP-UX > ignite. - Hp Forum Moderator

0 Kudos
Reply
1 REPLY 1
Robert_Jewell
Honored Contributor

‎01-24-2014 09:29 AM

‎01-24-2014 09:29 AM

Re: Clone B2600 System to C3600

Did you try booting into interactive mode?  you can then setup the disk configuration manually and that would help with the pathing issues.

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.