Fixing device files with H/W Path?

[Davor Bira?]

Hy,

is it possible to fix some device file with some H/W Path thru procedure of make_tape_recovery?
e.g. there is disk with H/W path of 0/0/1/1.2.0
and with device file of /dev/dsk/c1t2d0.

So my questionis: Where can be writen during procedure of make_tape_recovery, anything what is on 0/0/1/1.2.0 should have device number /dev/dsk/c1t2d0?

Thanks,
Davor

[Robert-Jan Goossens]

I'm sorry, I don't understand your question in combination with ignite.

You can use the rmsf and insf commands to remove and create special device files.

Robert-Jan

[Uday_S_Ankolekar]

If you want to change the insance number of a device then follow the steps given in this doc

Procedure 2 works. I have tried it.
http://www2.itrc.hp.com/service/cki/search.do?category=c0&mode=id&searchString=KBRC00004879&search.x=29&search.y=5&searchCrit=allwords&docType=Security&docType=Patch&docType=EngineerNotes&docType=BugReports&docType=Hardware&docType=ReferenceMaterials&docType=ThirdParty

Good luck

-USA..

[Davor Bira?]

Yes, I want to change instance number of some devices, but I would like it to do thru procedure of make_tape_recovery, thru some config_file like system_cfg or something similar?