HPE Community
Operating System - HP-UX
1752794 Members
6207 Online
108789 Solutions
New Discussion

How to setup Ignite Server to distribute a golden image

 
SOLVED
Go to solution
Lor
Frequent Advisor

‎04-30-2008 09:12 AM

‎04-30-2008 09:12 AM

How to setup Ignite Server to distribute a golden image

New to Ignite product, I seek advise to understand overall steps to conduct objective described below.
Can someone summarize overall steps and list HP-UX instructions.
Appreciated. Will assign points.
Hugues

I have on disk a golden image file which is the output of a "make_sys_image" command of a specific server.
In remote Disaster Recovery site, I need to test how to set-up a new Ignite server from scratch and configure it to make golden image available to other HP-UX 11.23 servers during Disaster Recovery procedure.
Could someone recommend an action plan and provide overall configuration steps required.
0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎04-30-2008 10:12 AM

‎04-30-2008 10:12 AM

Solution

Re: How to setup Ignite Server to distribute a golden image

This doc applies to vPars and golden images, but it applies even to all other systems, more or less:

http://docs.hp.com/en/6770/golden.images.pdf


All ignite stuff is here:

http://docs.hp.com/en/IUX

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.