Ignite UX

[Kenrick Sy]

Hi,

What is the command for executing ignite UX? I plan to do a backup of system image.

Thanks.

Kenrick

[Norman_21 · Accepted solution]

make_tape_recovery -Iv -x inc_entire=vg00

hope this help

[Joseph Loo]

hi,

try this:

# /opt/ignite/bin/make_tape_recovery -x inc_entire=vg00 -I -v -a /dev/rmt/0mn

please use make_tape_recovery and not make_recovery cause that is the latest.

for downloads:

http://www.docs.hp.com/en/IUX/download.html

regards.

[Norman_21]

Just a small note, if you don't specify the -a /dev/rmt/0mn as mentioned, the default tape will be used.

using the no rewind (xmn) is always safe!

[Kenrick Sy]

Thanks for your reply. do I need to pay for downloading Ignite UX on HP website?

[Norman_21]

Nope, it's free!

www.software.hp.com

[Joseph Loo]

hi,

absolutely not. just download from the link i have given.

regards.

[Kenrick Sy]

I'm downloading the ignite ux software for HP-UX 11i. By the way, what are the patches needed after installing ignite ux? The website tells us something on the required pax patches.

Thanks.

Kenrick

[Norman_21]

You must download and install PAX patch prior to running Ignite to ensure a good ignite tape:
PHCO_30420 for 11i

PAX is a command that works like tar

man pax for more info

[Norman_21]

Sorry, the recommended one is 32438:
http://www1.itrc.hp.com/service/patch/search.do