Operating System - HP-UX
1748211 Members
4646 Online
108759 Solutions
New Discussion юеВ

Re: boot from ignite server fail

 
miracle
Frequent Advisor

boot from ignite server fail

Hi experts,

yesterday I was having problem trying to ignite a system from an igniter server. The ignite server runs 11i and has March 2003 patch. What I was trying to do was remove the two old disks from my A400 (client) and ignite the new 36Gb drives from the ignite server on the client. The client has been backing up to the ignite server without any problems. After installing the new disks, I halted the boot procedure. From the BCH menu I tried this

bo lan xx.xx.xx.xx install
interact with ISL (tried yes and no)
After some time I get message saying "failed to initialize"

Both systems are on the same subnet
I've tried searching forums but seem to not find solution to my problem, please help me.

Here is the output of 'instl_adm -d'

# instl_adm defaults:
# NOTE: Manual additions between the lines containing

"instl_adm defaults"
# and "end instl_adm defaults" will not be preserved.
server="xx.x.xxx.xx" (ignite server IP)
netmask[]="255.255.0.0"
route_gateway[0]="xx.x.xx.x"
route_destination[0]="default"
# end instl_adm defaults.

I also did a search lan, but no devices were found. thanks MM
4 REPLIES 4
Steven E. Protter
Exalted Contributor

Re: boot from ignite server fail

I do recommend bringing Ignite up to date.

http://software.hp.com/portal/swdepot/displayProductInfo.do?productNumber=IGNITEUXB

Also, note that you can not boot off an Ignite server with any other lan card than the build in LAN card on the box. You can transfer the ignite data through your add in gigabit card, but not the boot process.

If necessary set up a crossover cable or hub for booting to remedy this situation.

You can watch the attempted boot on the Ignite sever for real time evidence of connectivity with one or both of the following procedures.

ps -ef | grep boot

tail -f /var/adm/syslog/syslog.log

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
miracle
Frequent Advisor

Re: boot from ignite server fail

Hello SEP,

The ignite version is "B5725AA B.4.3.123"

I look at both system, client is using 10/100 in built LAN card. Server uses gigabit card. Is this the reason? If I install additional cable from in-built card on server, should this then work?

thank you for information
Simon Lowther
Advisor

Re: boot from ignite server fail

try linkloop from the server to the mac address of the clients built-in interface

if linkloop doesnt work then server and client are not physically connected to the same network segment, check cables link lights etc.
miracle
Frequent Advisor

Re: boot from ignite server fail

Thank you Simon
I will have a look at this command