HPE Community
Operating System - HP-UX
1751713 Members
5063 Online
108781 Solutions
New Discussion юеВ

make_tape_recovery

 
SOLVED
Go to solution
ITeam
Super Advisor

тАО05-15-2002 01:06 AM

тАО05-15-2002 01:06 AM

make_tape_recovery

Trying to run "make_tape_recovery -i" on 11i and getting the following error message "vxvm:vxprint: ERROR: IPC failure: Configuration daemon is not accessible". Can anyone tell me what I need to check to make sure that Ignite UX is installed correctly?
0 Kudos
Reply
2 REPLIES 2
Sridhar Bhaskarla
Honored Contributor

тАО05-15-2002 01:11 AM

тАО05-15-2002 01:11 AM

Solution

Re: make_tape_recovery

Looks like the Veritas Volume Manager configuration daemon is not running. Probably you might have not setup the disk groups. Try setting up a disk group and see if it works.

-Sri
You may be disappointed if you fail, but you are doomed if you don't try
Reply
S.K. Chan
Honored Contributor

тАО05-15-2002 01:15 AM

тАО05-15-2002 01:15 AM

Re: make_tape_recovery

The error simply means that VxVM product is installed but not configured. If you plan to use VxVM then you got to make sure you run "vxinstall". Otherwise swremove the VxVM fileset/product (HP VERITAS Volume Manager) and make_tape_recovery should then run fine.
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.