Simpler Navigation for Servers and Operating Systems - Please Update Your Bookmarks
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
If you have bookmarked forums or discussion boards in Servers and Operating Systems, we suggest you check and update them as needed.
Insight Control for Linux
cancel
Showing results for 
Search instead for 
Did you mean: 

bnx2 device eth0 does not seem to be present

SOLVED
Go to solution
Ireneusz
Occasional Visitor

bnx2 device eth0 does not seem to be present

I have DL360G5 with RHEL 4.2.
I have installed psp 8.3 and since that moment my system does not recognize network card. On the live chat I was advised by HP expert to install psp 8.4 so I did it but doesn't help at all. During system start up system fails to recognize NIC. When I try to make NIC active it says "bnx2 device eth0 does not seem to be present". In message log I have information: "kernel: bnx2: version magic '2.6.9-42.ELsmp SMP 686 REGPARM 4KSTACKS gcc-3.2' should be '2.6.9-42.ELsmp SMP 686 REGPARM 4KSTACKS gcc-3.4"
Please advice how to fix it or remove psp and comeback to original state.
3 REPLIES
Michal Kapalka (mikap)
Honored Contributor
Solution

Re: bnx2 device eth0 does not seem to be present

Ireneusz
Occasional Visitor

Re: bnx2 device eth0 does not seem to be present

Hi just to the point. Now server is back fully functional. Thx.
Ireneusz
Occasional Visitor

Re: bnx2 device eth0 does not seem to be present

I implemented advised procedure.