failed to deploy an image ice V2.01

[klemerS]

Thanks.

I can open a new case & send you sosreport if you wish. we tried the capture 3 times with same results. we even export vgcrash but got same results.

we tried to delete all none relevant disks from the xml file including vgcrash & on the partition page we got the partition table.
we saw as mountpoint only / + /opt .all other lvols were without mountpoint.

the Deploy start o.k. but failed later

regards

Shalom.

[Mark Schroeder]

It sounds as if removing the (odd) partitions with two "pvdevice"s at least got the partition wizard GUI to load ok. Correct? Then some other volumes were missing mount points in the partition wizard and the deploy failed. Also correct? (Just checking my understanding.) If so, you've probably hit two independent defects.

Can you try this?

* Remove the non-essential (odd) partition with the two "pvdevice"s. This should allow the partition wizard GUI to load properly.

* For any partition in the wizard that does not show a mount point, edit that partition and set its mount point. Each partition must have a mount point set, but the partition wizard incorrectly assumes that the partition "label" contains the mount point and that is not always the case. This issue has recently been release noted. Setting the mount point by hand by editing the partition information is the workaround.

* Once all partitions have mount points set in the partition wizard, "continue" in the partition wizard and perform the deploy.

I would like to know if the above steps result in a successful deploy.

[klemerS]

O.K. thanks !!!!!!

I just sent what you asked to customer.

hoping for quick answer.

Regards

Shalom.

[Mark Schroeder]

This has remained open for some time. Perhaps the workaround solved your problem. I am still concerned that you had
a bad capture (two pvdevice entries).

What can we do to reproduce the bad capture? Do you understand what about
your configuration is causing that to happen?

[klemerS]

Hello.

I am sorry for the delay.

i wasnt working for 3 weeks.

Customer told me he cant tests the systems since its goes to production.

he will do some tests on other systems in the next 2 weeks.

I will soon close the case.

Thank for your help !!!!

[klemerS]

Hello Again.

Our Error happened again with other system.

this system connect to EMC too , but the OS is on local disks.

We did what Mark suggested & its worked. The deploy works fine on one system & failed on another , But from the deploy error on second bl460c its seems like a known problem , which V2.10 solves.

"aer : probe of 000xxx:pcie01 failed with error 2"


I opened a case regarding the double PV. I will send the image xml file & sosreport from source bl460c.


Best Regards.

Shalom.

[klemerS]

hi.

Sorry for the Delay.

i got an answer , to upgrade the ICE version to solve the problem.
thanks to all.

Shalom.