- Community Home
- >
- Services
- >
- Insight Remote Support
- >
- Switch Brocade stucked at Local Only@OSEM
Insight Remote Support
1753808
Members
8356
Online
108805
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-06-2009 02:18 AM
05-06-2009 02:18 AM
Switch Brocade stucked at Local Only@OSEM
Hi,
I configured my brocade switch HP StorageWorks 4/256 SAN in order to be monitored by SIM+RSP.
I'm receiving the events from this switch but when I check under All HP Service Events if the events were sent to HP backend I see Local Only@OSEM.
To configure the switch I followed the instruction from A.05.20 CMS Prerequisites and Managed Systems Configuration Guide capture 10.3 Brocade SNMP Configuration. My expectation where that when I get the event from that switch that this event would be submitted to HP and Local Only@OSEM.
Does anybody else had the same problem?
Thank you
I configured my brocade switch HP StorageWorks 4/256 SAN in order to be monitored by SIM+RSP.
I'm receiving the events from this switch but when I check under All HP Service Events if the events were sent to HP backend I see Local Only@OSEM.
To configure the switch I followed the instruction from A.05.20 CMS Prerequisites and Managed Systems Configuration Guide capture 10.3 Brocade SNMP Configuration. My expectation where that when I get the event from that switch that this event would be submitted to HP and Local Only@OSEM.
Does anybody else had the same problem?
Thank you
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-17-2009 01:33 AM
12-17-2009 01:33 AM
Re: Switch Brocade stucked at Local Only@OSEM
No solution found
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP