System Insight Manager did not found the EVA 8000 and Webes failed to communicate with HPSIM.

[InformationSystemsCente]

webes 5.6 sp1
System Insight Manager 5.3
EVA8000
Command View 9.1 recently update from 8.0

We have two problems
System Insight Manager did not found the EVA 8000 and Webes failed to communicate with HPSIM.
Before we start the upgrade Command View from 7.0 to 8.0 we had installed webes 5.6 and SIM 5.3. EVA8000 and all the components was detected from SIM .
After the upgrade of Command View to 8.0 the Webes start sending messages “Webes failed to communicate with HPSIM” we make all the necessary steps that the mail writes but the mails continue to come . The final solution was to reinstall the SIM. After that the SIM did not find EVA8000.
We upgrade Command View 8.0 to 9.1 also upgrade the firmware of controllers of EVA8000 , disks and also the Webes 5.6 sp1 the problem continues (SIM did not find the EV8000, the messages continues to come )

[ITRC Test-CH]

The lates version of the IRSA Managed Systems Guide describes how to configure the command view communication to HP-SIM and WEBES.
It is also necessary to install ELMC_WCCproxy 2.5 or newer onto that system, where command view is installed.
WBEMDISCO (to be found on the CMS) is helpful to check the communication credentials, which are necessary to access command view.

Regards, Werner